stopdaa.blogg.se - Hard drive not showing in disk utility

Also, consider plugging the other SATA cable into a different SATA port. If the new HDD shows up here but you can’t see it inside Disk Management, power off your computer and replace the SATA cable connection your HDD to the motherboard with a different one. Once you get inside the BIOS settings, go to the Boot tab (or Boot Device Priority) and see if your new HDD shows up there.

Note: You can also search online for your specific BIOS Key. Press the BIOS key during the startup procedure But if you don’t see it, try pressing one f the F keys (F2, F4, F8, F10, F12) or the Del key (for Dell computers). Most motherboards will show the Setup key during the initial boot (somewhere on the bottom of the screen). You can access your BIOS settings by pressing the Setup key repeatedly during the very start of the Startup procedure.

A quick test to see if this scenario might hold true in your case is to access your BIOS settings and see if the new HDD is showing inside your BIOS settings. The same goes for a partially broken SATA port. If the SATA cable connecting your new HDD to your motherboard is partially broken, it might not pass your os requirements, so Windows will not show it inside the Disk Management Utility. Method 1: See if HDD is showing up inside your BIOSĪ lot of users have managed to get the issue resolved after discovering that they were, in fact, dealing with a hardware issue. Below you have a collection of methods that other users in a similar situation have used to get the issue resolved.įor the best results, follow the methods presented below in order until you encounter a fix that is effective in getting the issue resolved. If you’re struggling to resolve this particular issue, this article will provide you with a list of verified troubleshooting steps. New HDD is perceived as a foreign disk – Several users that encountered this issue for the same reasons have managed to get the issue resolved by importing the foreign disk inside the Disk Management utility.SATA (RAID) driver is not installed or corrupted – A number of users have reported that the issue was fixed after they re-downloaded and installed the SATA (RAID) driver from the motherboard manufacturer’s website.

HDD is included in a storage space – Several users have managed to resolve the issue after deleting the Windows virtual storage space that was using the HDD.

This will force your operating system to find all the ATA devices again.

Windows is unable to find ATA devices – There are several reports of users that have managed to resolve the issue after they deleted all ATA channels from IDE ATA/ATAPI controller.

Faulty SATA cable – If your HDD is showing in your BIOS Settings but it’s not showing inside Device Manager, it’s usually a clue that the SATA cable or port is faulty.